These heavy duty cams replace the upper control arm mounting bolts. Remove the O.E. bolts and replace with cams, rotating them to provide camber and/or caster adjustment. It may be necessary to remove O.E. slugs and elongate the bolt holes with 74910 punch. 83790 contains 2 cams to cover one side of the vehicle.

California Residents WARNING

These offset pin joints replace the upper jin joints on late model Dodge Trucks. They come in 1/2 degree increments and provide for independent wheel caster and/or camber changes up to 1-1/2 degrees. Use installation sleeve set 23780 in conjunction with ball joint press 72509 for quick removal and installation of the pin joints. -------------NOTE: 23800 is an OEM Replacement Ball Joint with no change in camber or caster.

California Residents WARNING

Due to a factory recall for 2006-12 Toyota RAV4's, much of the third generation of this popular platform no longer has provisions for rear toe adjustment. Replace Toyota's non-adjustable rear arm with SPC's adjustable link and get the toe changes needed to avoid premature tire wear. SPC's R&R rear link provides ±3.0° of toe change.

California Residents WARNING

Many of the early Toyota RAV4 models no longer have rear toe adjustment due to a factory recall. This arm fits these early recalled models as well as the later models. This simple to replace lower control arm provides a full ±3.0° of toe adjustment to get tire wear and adjustability back to when the vehicle was new.

California Residents WARNING

These heavy-duty axle caster shims can also be used to adjust pinion angle on Jeep CJs and similar vehicles with 1-3/4" to 2" wide leaf springs. 4 degree taper. Six shims per box.

California Residents WARNING

These HD 'King Pin' style joints replace the original sliding-ball design upper joints on late-model 4500 and 5500 Dodge trucks and rebadged Sterling Bullets. They provide independent adjustment up to 1.0 degree of camber change. * Note: 23850 is an OEM Replacement Ball Joint with no change in camber.

California Residents WARNING

These HD 'King Pin' style joints replace the original sliding-ball design upper joints on late-model 4500 and 5500 Dodge trucks and rebadged Sterling Bullets. They provide independent adjustment up to 1.0 degree of camber change. * Note: 23850 is an OEM Replacement Ball Joint with no change in camber.

California Residents WARNING

These HD 'King Pin' style joints replace the original sliding-ball design upper joints on late-model 4500 and 5500 Dodge trucks and rebadged Sterling Bullets. They provide independent adjustment up to 1.0 degree of camber or caster change (camber only on 4WD models due to outboard axle seals) to correct camber or cross-camber issues or to add caster on RWD models for improved tracking. * Note: 23850 is an OEM Replacement Ball Joint with no change in camber or caster.

California Residents WARNING

This camber adjuster lets you easily adjust camber on the newer Explorer/Mountaineer fully independent rear suspension systems. Full range of camber adjustment can be made by replacing the stock alignment washer on the rear lower control arm and installing the plate and cam nut. Camber can then be adjusted by turning the cam nut until the desired readings are obtained.

California Residents WARNING

These offset pin joints replace the upper jin joints on late model Dodge Trucks. They come in 1/2 degree increments and provide for independent wheel caster and/or camber changes up to 1-1/2 degrees. Use installation sleeve set 23780 in conjunction with ball joint press 72509 for quick removal and installation of the pin joints. -------------NOTE: 23800 is an OEM Replacement Ball Joint with no change in camber or caster.

California Residents WARNING

Twice the coverage - half the inventory. Changes caster positive or negative from 1/2 degree to 4 degree. APPS: Any solid axle RWD or 4WD vehicle.

California Residents WARNING