Installing Adapter for 72509 bushing press

California Residents WARNING

Installing cup for #7250 ball joint press

California Residents WARNING

The OE rear toe link bushing on many Subarus and the Scion FR-S can be easily removed when using the 67647 Bushing Press Adapter. Our Eccentric Toe Bushings (part# 67660) can then be installed using the adapter and a 72509 Ball Joint Press, or equivalent.

California Residents WARNING

The sleeves are designed to match the angle of the yoke on the axle housing to insure proper installation. Sleeve set 23580 is to be used with our Dodge & Jeep Offset Ball Joints (part nos. 23510, 23520, 23530, 23540). Use in conjuction with the 72509 Ball Joint Press.

California Residents WARNING

Remove and replace ball joints without "brute force" methods that can cause costly damage. Now you can take on 4WD ball joint service in addition to servicing most cars. A forcing screw-powered press, used with proper adapters, easliy removes and installs all press-fit ball joints (inc. GM plastic pin "U" type joints). Comes in a durable plastic case. Package Includes: #4437 - Press #4438- Forcing Screw, #29503- Receiver Tube(3" OD X 2-3/4" ID), #29504- Receiver Tube(2-1/2" OD X 2-1/4" ID), #29505- Receiver Tube(2" OD X 1-3/4" ID), #38354- 4WD Receiving Cup, #38355- Installing Cup, #204508- 4WD Installing Adapter, #305227- Installing Adapter, #305228- Removing Adapter

California Residents WARNING

Easily replace press-in type control arm bushings on many domestic and imported vehicles with this service kit. Mechanical power screw quickly and easily removes worn bushings and installs them without damaging the control arm. Set included C-Frame, screw assembly and all adapters to do the job quickly and correctly. Packaged in a durable plastic case. Set includes the following items: 4427 (3),4428,4429 4430,4431,4432,4433 and 4434. #4429 - 1/8" thick tube

California Residents WARNING

Adapter for 40920 set.

California Residents WARNING

C-Clamp with threaded forcing rod for the 40920 press set.

California Residents WARNING

This tool was specifically designed to remove the original equipment ball joints on smaller cars when installing SPC Performance's sliding ball joints. With this revolutionary design you can remove the ball joint from the front upper control arm without removing the arm from the vehicle, saving time and costs. Packaged in a convenient blow-molded plastic case this set comes complete with adapters for both removing and installing stock or Specialty Product's sliding ball joints. Set includes the following 4433,4434,40923,40925 and 40927.

California Residents WARNING

Adapter for 40920 set.

California Residents WARNING

Adapter for 40920 set

California Residents WARNING

Service a wide range of bushings with this versatile press set. Our 29 piece kit will allow you to efficiently remove and install bushings from 1 1/2" to 3" OD (36-80mm ). Save time by servicing the suspension bushings on the vehicle vs. removing components to use a shop press. The kit uses long ACME threaded screws and bearing nuts to make manual pressing a snap. Set includes: 4-ACME threaded spindles, 3 plate adapers and 22 sleeves in sizes from 34mm ID to 80mm ID.

California Residents WARNING