Replace the non-adjustable rear upper control arm on the Nissan Altima with SPC's fully adjustable arm to get ±2.5° of camber change. This remove and replace arm is perfect for traditional alignment correction, to enhance handling, or as a direct replacement chassis part.

California Residents WARNING

This replacement front adjustable strut rod is easily adjustable and gives these popular tuner vehicles the ability to change caster by 3°. A stiffer rubber bushing material provides better handling in performance applications.

California Residents WARNING

This pair of front upper control arms will give you +/- 1° caster and +/-2.5° camber change. Simply replace the OE front upper control arms and dial in your suspension angles with our patented sliding ball joint and caster plate. Whether you want to tune your suspension for the ultimate in handling performance, minimize tire wear or easily move back and forth between two settings, these are the arms to get the job done. These arms feature our Jounce Spacers for a quieter, OEM style ride.

California Residents WARNING

These rear arms provide an increased amount of camber change on these popular tuner cars. Two arms are required per side and are adjusted together to give the maximum amount of camber change without affecting wheel setback. Stiffer rubber bushing material is used for better handling in performance applications.

California Residents WARNING

Restore lost adjustment on Nissan Rogue and Juke models with this OE replacement rear camber bolt kit from SPC. Sold per wheel, order 2 kits to service both sides of the vehicle.

California Residents WARNING

These arms fit the popular Nissan Altima. Simply replace the OE fixed length lower rear control arm with this adjustable arm to achieve +/-3 degrees of camber change. Use the included toe cam bolt to get up to +/-2 degrees of toe change. The arm and cam kit can be used for vehicles with stock ride height or lowered for performance.

California Residents WARNING

This adjustable arm increases the amount rear toe can be changed on this popular performance vehicle. It is recommended that this arm be installed when either the 67765 or 67775/67776 is being installed.

California Residents WARNING

This easy to install full contact shim set is perfect for Nissan Versas and Renault Clios needing rear camber or toe adjustment. SPC's fixed change shims will provide ±0.5° to ±1.0° of toe change and camber change. Set includes 2 each 2 shims.

California Residents WARNING

With these shims you can correct both rear camber and toe on newer Volkswagens & Audis. By combining the shims (two may be used per wheel) you can get up to +/-.50 degrees toe Our wrench (87530) is a must when installing these shims. It allows you to remove the brake tone ring, bearing, seal and hub assembly as one unit. CAUTION: Check brake & rotor clearance for binding. 75970 spacers may be required. Set includes 16 shims/2 of each size and 87530 wrench.

California Residents WARNING

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding.75970 spacers may be required. DO NOT use spacers with AWD vehicles. SHIM SET - Includes 20 shims/2 of each size.

California Residents WARNING