Fix your rear toe on Hyundai Accent and Kia Rio modesl with this ±0.25° shim from SPC. Fix tire wear, thrust angle, and poor drivability by getting the rear toe back into specification. Work on a lot of Accents and Rios? Consider stocking the 71070 set that includes 2 each of the 0.13°, 0.25°, 0.38°, and 0.50° shims for maximum coverage and can be used for either positive or negative change.

California Residents WARNING

This easy to install full contact shim is perfect for European Models needing rear toe adjustment. SPC's fixed change shims will provide ±.13° to ±.50° of toe change.

California Residents WARNING

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding.75970 spacers may be required. DO NOT use spacers with AWD vehicles.

California Residents WARNING

With these shims you can correct both rear camber and toe on newer Volkswagens & Audis. By combining the shims (two may be used per wheel) you can get up to +/-.50 degrees toe Our wrench (87530) is a must when installing these shims. It allows you to remove the brake tone ring, bearing, seal and hub assembly as one unit. CAUTION: Check brake & rotor clearance for binding. 75970 spacers may be required.

California Residents WARNING

This easy to install full contact shim is perfect for European Models needing rear toe adjustment. SPC's fixed change shims will provide ±.13° to ±.50° of toe change.

California Residents WARNING

This fixed change arm is ideal for correcting excessive negative camber issues seen in lowered Scion tC's. The Scion tC comes from the factory with a cam bolt that provides ±1.25°. This factory change is not enough change for lowered applications. By increasing the length of the rear upper control arm SPC Performance adds 2° positive camber to the rear suspension that can then be dialed in with the OEM cam bolt.

California Residents WARNING

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding.75970 spacers may be required. DO NOT use spacers with AWD vehicles.

California Residents WARNING

3/4° Nylon Rear Shim.

California Residents WARNING

3/4° Nylon Rear Shim.

California Residents WARNING

3/4° Nylon Rear Shim.

California Residents WARNING

Dial in ±3° camber and ±2° toe to maximize your suspension set-up on the 350Z and G35 with this set of race ready adjustable rear lower control arms (RLCA), camber lockout plates, and extended range toe cams from SPC. Specifically designed for track use, the arms include SPC's xAxis sealed flex joints that perform like monoballs, but with non-metal bushings. These arms combine xAxis with forged steel receivers and straight-arm construction to minimize compliance under load. Included lockout plates will replace the OE camber cams to give you that extra assurance that your camber is locked in.

California Residents WARNING

This popular adjustable upper control arm/shim kit has been re-designed to match the SPC family of Nissan and Infiniti arms. Our new tubular design has reduced weight by 1 pound per arm and increased rigidity. SPC's arms are the only 350Z arms on the market that can get +3.5° to -1.5° camber change. Additionally, you will be able to set your caster at ±1.0°. This patented design makes camber and caster adjustment easy using the sliding and rotating ball joint. The kit includes everything needed, including the ABS sensor bracket, shims, and the adjustable arms.

California Residents WARNING